USMC 18mm ( United Space Marine Corps )

Here are my USMC,

Check out the previous posts.

The flying APC's/Air Taxi ( still have to come up with a suitable name ) are scratchbuilt. laser cut card, coffee pod end bits & 3D printed weapons. The Spin washing liquid drop pod is also finished ( I did 5 of them + generic decals , though not in pics ). The mechs are 3d printed.

I need to do the power armour next.

I have added the USMC insignia for those who might need it. Nothing says space than Saturn.

Thanks for your comments.

 Z

Scratch built 18mm USMC Sci-Fi lander Finished

Hello again all,

Here are the finished models.

Thanks for your comments. Z

Scratch built 18mm USMC Scifi Lander

It has been some time since I scratch built something.

I got these 6mm minis which are great for 15/18mm also & decided to build them a transport, sort of a Sci-Fi Chinook.

https://cults3d.com/en/3d-model/game/jais-carabinere

These are my Usmc in space. Possibilities are endless .

Quite nice minis with very nice poses especially the seated ones, though I did kitbash them like the side HMG gunner who is prone in the set.

The Transport's build is mostly card with egg plastic carton bits ( the transparent plastic parts ). The front part can be detached from the back with a slot and magnet. Back can carry infantry & vehicles/drones.

I will do 2 engine versions -  Atmospheric turbo fans ( juice pack caps ) and Space travel Jet engines ( empty 35mm film roll cases which I had for years ). Magnets & thin galvanised sheet metal sheets will be used to enable quick change. Sheet metal is used in engineering but any iron based food can like a sardine can's lid can be used ( careful very sharp ) . Use a magnet to check tin before buying 😉at the supermarket. Or simply just use 2 magnets . easier.

Magnets & sheet metal bits will also be used throughout to hold back door & infantry in place. The side doors can be covered with card/foam pieces.

Must think of a suitable Usmc name for it now. Marines have a particular way to name things & these names always seem to stick like gum to a shoe. Suggestions ?

Front part can be place at different heights. Next landing gear will be done ( thanks to Warmonkey for pointing this out ). I will have to find a way to make the landing gear height adjustable. 3d printed perhaps ?

Thanks for your comments.

Z

Scratch built or converted 18mm Scifi vehicles

Hello again,

These are failed 3d prints . All are PLA. Used card, other 3d printed parts etc to make something out of them , instead of throwing them away. 

Thanks for your comments. Z